Design a drag for the 306?
The original drag for the 306 consists of a spring that sits directly on a plastic washer or spacer of some sort. Not even a teflon washer (or if there was it's not there now and isn't on the schematic). I'm hoping that I can come up with a better solution that might stand up to a few kings while i'm in Gulf Shores. I Was thinking about using a few ht-100 washers sandwiched around steel washers that are fitted to the axle/spindle (round with a flat side). Not sure if I need to keep a spring or not. Any of you do it yourselfers have a thought or two about this?
